Darwin is our primary stimulus presentation computer. It is usually connected to the monitor on the left.
Darwin has the following peripheral hardware connected:
Measurement Computing Analog/Digital data acquisition device (USB-1208FS, dev=0, 8 a/d chans)
E-Prime dongle connected to USB port
Scanner trigger cable connected via SRbox (code=16), and MeasComp analog (ch 5) and digital (B0), biopac analog CH 9
Scanner trigger is also connected to the MCC counter pin (CTR), this would show up as a number increase NOT a positive pulse
Biopac belt respiratory signal connected as MeasComp analog input (ch 0, w/ 1Kohm resistor), biopac analog ch4
Biopac cardiac signal connected as MeasComp analog input (pulse ch3, OxSat ch4), biopac analog ( o2 ch3, pulse wave ch7, pulse rate ch11)
BioPac GSR signal connected as MeasComp analog input (ch 1)
BioPac EGG signal connected as MeasComp analog input (ch 2)
Measurement Computing Box, DigPort-A0 Output to Analog Ch6 In, to BioPac Analog 8 input
Measurement Computing Box, DigPort-A1 Output to Analog Ch7 In