jvs:cigal:showplay:manual:chapter1:ppf
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
jvs:cigal:showplay:manual:chapter1:ppf [2011/07/18 21:58] – voyvodic | jvs:cigal:showplay:manual:chapter1:ppf [2011/07/18 22:00] – voyvodic | ||
---|---|---|---|
Line 5: | Line 5: | ||
The parameter settings section appears first and is used to specify parameters to use during the paradigm. These can be any CIGAL commands, but typically just involve setting global variable values. After the parameter section there should be a blank line, followed by the stimulus timing list, organized as a table. Each line in the table specifies a separate stimulus event. | The parameter settings section appears first and is used to specify parameters to use during the paradigm. These can be any CIGAL commands, but typically just involve setting global variable values. After the parameter section there should be a blank line, followed by the stimulus timing list, organized as a table. Each line in the table specifies a separate stimulus event. | ||
- | The following is an example of a simple input file that mixes graphics, pictures, text, movies, and sound stimuli. (Text following a ';' | + | The following is an example of a simple input file that mixes graphics, pictures, text, movies, and sound stimuli. (Text following a ';' |
showplay 0 ; initialize new showplay task | showplay 0 ; initialize new showplay task |
jvs/cigal/showplay/manual/chapter1/ppf.txt · Last modified: 2024/06/21 15:44 by 127.0.0.1